Newsflash

Our family of electrical motors has been extended. Check out the motors section!

×

Message

EU e-Privacy Directive

This website uses cookies to manage authentication, navigation, and other functions. By using our website, you agree that we can place these types of cookies on your device.

You have declined cookies. This decision can be reversed.
ALL-USB

ALL-USB Programming Adapter


ALL-USB is a universal (RS232 and CAN) programming adapter which enables communication with programmable Piktronik devices, such as SAC drives, KOP battery chargers, control systems, etc. via the USB port of a personal computer. ALL-USB programming adapter thus directly replaces the SAC-USB and KOP-USB2 programming adapters.

The ALL-USB programming adapter allows diagnostics and parameter setup for:

  • all Piktronik modules (chargers, motor controllers, BMS etc.) that communicate over CAN bus (supports all CAN 2.0B standard baud rates up to 1 Mb/s),
  • KOP charger models that communicate over the PTC connector,
  • PD3 DC drive motor controllers,
  • SAC motor controllers that communicate over the RS232 interface.

The following Piktronik PC software packages support the ALL-USB programming adapter:

  • CANterm,
  • ARMboot,
  • PDTERM,
  • KOPTERM,
  • SACTERM and
  • KOPPROTTERM.

The adapter will be delivered together with the appropriate USB cable and Software on the CD.

ACCESSOIRES

Additional adapters (cables) have to be ordered separately to enable programming of older modules. Please contact Piktronik before placing an order.

DRIVER DOWNLOAD

For Windows 8 and Windows 10, the driver installation is built into Windows. Manual driver installation is necessary only for Windows 7 and older operating systems.